Meade ETX-125PE

This page covers day-to-day use of the Meade ETX-125PE. Meade published official procedures for hardware changes; the photos below document LNT module removal as performed on this unit.

Removing the LNT module

Meade documents this process in detail. In short:

1. Remove two screws so the LNT module can be lifted off the OTA. One screw is obvious on the right; the less obvious screw is on the left (pointed out in the photo).
2. Lift the LNT and disconnect the white plastic connector.
3. Replace the two screws — done.

Links

• Weasner’s Mighty ETX Site — long-running community resource

Last modified on the original site: January 25, 2009